Tuesday, March 15, 2011

Ricki Dwyer: Peach Pit

Using the same scan I printed this model on the FDM 3d printer as a maquette for a larger sculpture. The smaller peach pit implies the scale of a human being in comparison to the sculpture, if this piece were to be completed.

These are the laser cut pieces compiled into the form. A cardboard peach pit approximately 14 inches tall.

After scanning in a peach pit, using a 3D scanner, I created a model on Rhino serially sliced it into horizontal planes that I can then cut on the laser cutter.

No comments:

Post a Comment